To check the batteries or battery tubes within an SDL, it may become necessary to remove the white SDL cap.

 

P1040615

Figure 1: Note the white SDL cap

 

Carefully unscrew the white cap going counter-clockwise.

 

P1040616

Figure 2: SDL Cap partially removed

With the cap removed, batteries may be replaced. Battery tubes can be checked and o-rings can also be inspected. Whenever the cap will be reattached to the SDL, be careful not to cross-thread while tightening it back on.

P1040617

Figure 3: White SDL cap removed. Inspect o-rings, check battery tubes or change batteries as needed.

 

REV: 13J06

Leave a Reply

Your email address will not be published. Required fields are marked *