To directly connect to a 5500-iSIC data logger, simply unplug the Ethernet modem RS-232 cable from the iSIC data logger’s DB9 port and plug in an RS-232 cable directly connected to a PC running iChart software.

 

DB9

Figure 1: RS-232 Cable connected to an iSIC data logger’s DB9 port

 

If the 5500-iSIC is already setup in iChart, select it from the Navigation Panel and then right-click and select Property. Change the Connect Through setting to “Direct to PC”.

 

DirectToPC

Figure 2: Change to “Direct to PC”

REV: 13G31

 

Leave a Reply

Your email address will not be published. Required fields are marked *