Cycle Power on an iSIC Data Logger

1. Open the lid of the iSIC enclosure.
2. Remove both black fuses located to the left of the green digital terminal strip by pressing down on the holder cap and turning it counterclockwise.
   

   Remove Battery and External fuses inside the iSIC enclosure.

    
3. Wait 10 seconds.
4. Re-install the Battery fuse followed by the External fuse to re-apply power to the system.
5. A green LED visible through a pinhole adjacent to the analog terminal strip will illuminate. During the iSIC bootup process this light will blink slowly a few times followed by a set of rapid flashes before turning off.
   

   Confirm the iSIC is powering up via the green LED boot flash pattern.