Knowledge Base

Mount an X2 Environmental Data Logger


The X2’s mounting kit accessory provides an easy way to attach the logger to a pole, pipe or wall. Mount an X2 to a 1-1/2 to 2″ (38 to 50 mm) pole by following the instructions in this guide. Alternatively, user-supplied screws may be used to mount an X2 to a wall.

X2 Mounting Kit Installation

  1. Attach the bracket to a pole using the included 5/16″-18 x 2″ U-Bolt, 5/16″ flat washers, 5/16″ lock washers, and 5/16″-18 nuts. Tighten with a 1/2″ socket driver or wrench.
Mount an X2 to pole

Figure 1: Install Pole Bracket with U-bolt.

 

  1. Use the included 3/8″-16 x 1-1/8″ socket head cap screw to attach the mounting bracket to the bottom of the X2 with a 5/16″ hex driver.

Figure 2: Attach security screw.