If advanced diagnostics or repairs are to be performed on an SDL500 submersible data logger, the outer housing must be removed. 1. Remove the (4) 3/16″ hex screws from the main SDL500 body on the end with 5 ports (bottom bulkhead). 2. Pull the bottom bulkhead off of the main body carefully. Note: Since the SDL500 is air-tight […]
Analog sensors require a millivolt (mV) reading in order to determine an accurate output. To find these readings, follow the process below. 1. Open iChart without a project file. 2. Select Advanced|iSIC|iSIC from the menu bar. 3. Select the appropriate communication under PC Settings. 4. Type the address of the data logger and click Connect. 5. Click the Analog tab. […]
Switch power is used in data logging applications where power must be conserved. There are two separate implementations of this concept within the iSIC data logger. Sensor Switch Power Sensors plugged into SDL ports P1, T, and A or powered through pin 2 of an iSIC’s digital terminal strip are powered using switch power. This […]
Each SDL500 submersible data logger includes the following accessories and spares to get started and keep the unit operational: SDL500 USB interface cable (Only included with direct connect SDL500, not with telemetry-enabled models) USB driver CD* (8) D-Cell alkaline batteries Maintenance kit SDL Guard removal tool (3/16” handled Allen wrench) (2) Spare SDL port plugs […]
The SDL500 Submersible Data Logger is configured with five sensor ports for connection to industry-standard digital and analog interfaces, including RS-232, RS-485, SDI-12, 1-wire temp string, 0-2.5 V, pulse count, and more. Each sensor port offers a UW (underwater) type receptacle with double oring seal for a reliable waterproof connection. Unlike many data loggers, the […]
Direct connection with RS-485 can be established by using a UW-USB-485P cable to communicate with the SDL500C, SDL500R and SDL500I. To do this: 1. Plug the USB cable into a computer. If it is the first time the USB cable is plugged into the computer, drivers (software) will be needed – an internet connection is […]
The maintenance switch is a feature in iChart software that can be used for external control of an iSIC data logger. Once the feature has been enabled and a channel has been set, a simple switch controls if the iSIC logs data or not. 1. Open iChart without a current project. 2. From the menu […]
NexSens iSIC data loggers have a default address of 1. When connecting multiple iSICs to a single PC COM Port, unique addresses must be assigned to differentiate between them. This problem occurs most often when using a system of 4100-iSICs. 1. Open iChart without a current project. 2. From the menu bar select Advanced |iSIC | […]
In order for a base radio to communicate with iChart, the correct COM port needs to be selected. Sometimes the base radio’s COM port and the port that iChart checks for the base does not match. If this is the case, the best option would be to change the COM port that iChart checks for […]
The iSIC data logger’s DIO0 and DIO1 lines are programmable digital input/output signals. In revision 6, the signals are 5V logic and can tolerate up to 6V. In revision 7, the signals are 3.3V logic and can tolerate up to 35V indefinitely. The most common use of these lines is to use them to drive […]
