The LED only flashes when the iSIC is booting up and does not stay on all the time in order to conserve battery power. The LED will flash immediately upon connecting the battery but only for 15-20 seconds. REV: 13G29
5100-iSIC
Switching a NexSens Logger from SDI-12 or Modbus to RS-485
NexSens iSIC and SDL500 data loggers can communicate using interfaces such as SDI-12, Modbus RS-485 and RS-232. This process shows how to switch from SDI-12 or Modbus to RS-485 communication in order to allow connection to a PC. 1a. Open iChart without a current project. 2a. From the main menu select Advanced | Terminal… 3a. Select […]
Code Update From Boot Loader
It may be necessary to perform a code update while in the boot loader if the normal code update is failing. 1. Open iChart. 2. Connect the data logger to the computer. 3. Select Advanced | Terminal from the menu. 4. Select Direct connect as the Connection type. Select the PC COM Port to which the data logger is […]
Remove a PCB From Mounting Plate
It may be necessary to remove the PCB (Printed Circuit Board) from the mounting plate for inspection or replacement. 1. Remove all attached wires from the back of the PCB. Note that the specific wires will vary depending on the communication available. Note: Record all wire locations before removal if replacing the board. 2. […]
iSIC Digital Expansion Pinout
The iSIC digital expansion provides an additional four RS-232 port on a pluggable Phoenix terminal. REV: 13G26
Upgrade 3100-iSIC to 5100-iSIC
To upgrade from a 3100-iSIC to a 5100-iSIC, please follow the procedure below. Note: This article assumes that the 3100-iSIC is already open and that the PCB and cellular modem have been removed. 1) Use step drill bit similar to the bit pictured below. 2) Drill out the existing hole that contained the RF bulkhead as […]
Connect and Configure Generic mV Adapter
To connect an analog sensor to the iSIC that does not exist in the iChart’s sensor library, please follow the steps beleow: 1) In iChart, go to the Sensor step and select Generic from the drop down menu. Select Generic mV in the menu below. Click Add. 2) On the “Analog Sensor Property”, enter the full scale. Please note […]
Switching a NexSens Logger from SDI-12 or Modbus to RS-232
NexSens iSIC and SDL500 data loggers can communicate using interfaces such as SDI-12, Modbus RS-485 and RS-232. This process shows how to switch from SDI-12 or Modbus to RS-232 communication in order to allow connection to a PC. 1a. Open iChart without a current project. 2a. From the main menu select Advanced | Terminal… 3a. Select […]
Testing a Solar Panel
Solar panel kits may be connected to iSIC data loggers to recharge the 12V A01 iSIC battery. Solar charging kits are equipped with a charge regulator to prevent overcharging of the A01 battery and damage to the data logger or connected devices. Use the following process to identify and troubleshoot suspected issues with a solar panel kit. 1. […]
Manually Enable/Disable Switch Power
When setting up and troubleshooting a system, it may be necessary to manually enable or disable the logger’s switch power. 1. In iChart, open the diagnostic window by clicking on View | Diagnostic Window. 2. Connect to the data logger. See the appropriate iSIC Data Logger or SDL500 category for instruction on connecting directly to the […]