Overview The NexSens 5100-OEM is an iSIC data logger with an integrated Ethernet controller that provides communication over LAN or WAN. What’s Included Data logger with integrated Ethernet controller (2) Mounting flanges iSIC Kit (2) A75 Gland fittings (5) Desiccant packs A72 RS-232 interface cable iSIC resistor pack A78 CAT5E patch cable DB-9 null modem […]
Mount the iSIC box to a wall using the A55 mounting plate. It may be attached using the included hardware. First attach the plate to the back of the iSIC box using the (4) ¼-20 X ¾” bolts and then secure the mounting plate to the support surface. It can be attached to a pole […]
An MS2 connector is used to supply power to an iSIC Data Logger. It has two openings – one for power and the other for ground. An MS2 connector can be found on the A11 float charger (power adapter) and the solar panels of iSIC MAST systems. The port which connects the MS2 connector […]
1. Refer to the appropriate data logger category for instructions on connecting directly to the iSIC Data Logger or SDL500 that is being used. 2. In iChart, click Advanced | iSIC | iSIC. The iSIC Setup window will appear. 3. Enter the correct COM Port (Check the Port on the Device Manager by clicking Start | Right-click […]
In order to collect data from an iSIC that is connected to another iSIC, pass-through settings must be made in iChart. This article assumes an iChart project file and data loggers have already been programmed. 1. Right click on the data logger in the iChart Navigation Panel and select Property. The iSIC Data Logger Communication Properties […]
1. Uninstall the current Lantronix software. 2. Go to this link http://gridconnect.com/rs232-rj45.html and select Documentation. Click the link under Downloads to download a zip file that’s about 183 MB. 3. Extract the file. 4. Inside the Net232 folder, run the autorun.exe. 5. First run the “.NET Framework Install” if it isn’t (.NET 4) installed. 6. […]
After repairs or diagnostics, it may be necessary to reinstall an iSIC data logger’s circuit board. 1. Mount the PCB to the mounting plate using (4) M3 x 16 screws and (4) M3 lock washers. 2. Turn the mounting plate over, place an M3 lockwasher and an M3 hex nut on the one […]
(NEMA 4X Enclosure): 12” x 8.5” x 6.95” (inches) Analog Inputs: Standard: (4) differential or (8) single-ended | Optional: (4) differential or (8) single-ended additional | 0-2.5 V auto range. 12-bit resolution. Analog Output: Standard: (1) 12-bit channel | Optional: (1) 12-bit channel | 0-5 V or 0-2.5 V programmable Power Outputs: 12 V 100 mA […]
NexSens iSIC data loggers incorporate a precision real-time clock. However, the clock can drift up to two minutes per month and regional time changes require the clock to be synchronized periodically. This can be done manually or automatically. Confirm that the computer clock is correct Open iChart with a current project iChart must be opened […]
The 12V DC (direct current) batteries used on NexSens iSIC data loggers can be charged in two ways: online or offline. It will be necessary to decide which is most appropriate for the desired application. The necessary charger type can then be determined. Online Charging: If it is essential for the iSIC to always remain powered, […]
