Download the Latest ALEOS and Radio Module Firmware Navigate to Sierra Wireless’ RV50 firmware updates page here. Click the RV50 ALEOS X.x.x download link under the North America heading For International models of the RV50, select the associated downloads under the EMEA heading for South American, European, or African deployments and the APAC heading for […]
It is sometimes necessary to remove a cellular modem for replacement or repair. Disconnect the fastons from the battery terminals inside the iSIC. Remove the two screws on the battery plate with a #3 Phillips head screwdriver. Store the battery, battery plate, and screws. Unplug any external power devices connected to the MS2 port (e.g. […]
All cellular modems that are used with a NexSens iSIC data logger or CB-series buoy must be configured with the proper settings to communicate and transmit data. While NexSens generally makes the required changes prior to shipping the modem, it may become necessary for a user to verify or change a setting. This can be accomplished […]
Cellular data accounts must be provisioned properly to work with NexSens data loggers. To ensure the account will be set up correctly, notify Bell of all general account requirements during the initial account setup. Cellular Coverage Bell must offer good coverage in the area of deployment. Click here to verify the coverage in your area. Bell Specific Requirements Contact […]
Different cellular providers use different Access Point Names (APNs) to connect to the network. Use an Ethernet cable to connect the LS300 to the Ethernet jack on a computer Open a web browser and type the default IP address into the address bar as follows: 192.168.13.31:9191 The modem’s native AceManager will appear The default user […]
There are instances such as when a modem transfers cellular accounts that require a hard reset of the device. The following process will reset the device to manufacturer’s defaults and allow it to re-register on the network. Remove both black fuses (Battery and External) to disconnect power while taking the logger apart Remove the (4) […]
Some NexSens 3100-iSIC and SDL500 data loggers use the Sierra Wireless LS300 modem. The GPRS version of this modem requires user installation of a SIM card. 1. Remove all sources of power before opening the data logger. 2. If working with an SDL500, remove the outer SDL500 housing following the Remove SDL500 Housing article. If working with an iSIC, […]
1. Use an Ethernet cable to connect the LS300 to the Ethernet jack on a computer. 2. Open a web browser and type the default IP address into the address bar as follows: 192.168.13.31:9191 The modem’s native AceManager will appear. 3. The default user name and password is: user 12345 Enter this information and click […]
This article contains instructions on setting up a user-defined dynamic DNS. For the majority of NexSens applications, the default IP Manager service is preferred. Unless there are specific DNS requirements, click here for instructions on using the default service. 1. Use an Ethernet cable to connect the LS300 to the Ethernet jack on a computer. […]
Mount the iSIC box to a wall using the A55 mounting plate. It may be attached using the included hardware. First attach the plate to the back of the iSIC box using the (4) ¼-20 X ¾” bolts and then secure the mounting plate to the support surface. It can be attached to a pole […]
